Clamp designed to facilitate the assembly of flash and fibers in eyelets, designed for us by Eng. Guglielmo Todini. Optimized in every detail to obtain the maximum performance with a simple and clean design and a very high robustness, thanks to the type of plastic used.
The special internal foam, as well as holding the fibers when the clamp is closed, also acts as a push spring to facilitate the opening by pressing on the release lever, after inserting the fibers in the loop.

– 100% Made in Italy
– Five colors available: Green – White – Red – Blue – Grey
– Clamp total lenght: 117 mm.
– Store away from direct heat sources
– Do not store the clamp closed to maintain the elasticity of the foam
– Adjust cross screw when necessary to maintain smooth movement
– Packaging sizes: L180xW70xH13

CLAMP AND BASE TO FACILITATE THE MIXING OF DIFFERENT MATERIALS FOR USE IN DUBBING LOOPS
"With this tool, I wanted to give all fly tyers, from the most to the least experienced, the possibility to easily mix materials of all kinds (hairs, feathers, and synthetics), and then insert them into a loop to form a cord. Free hands and a stable support surface make this operation even easier and more precise. And now… enjoy!
Luca Barosselli"

INSTRUCTIONS FOR USE:
– Fully open the BlendMaster Clamp on a flat surface with the faces without prints facing upwards
– Arrange the chosen materials for your dubbing loop in the desired quantity and order, between the two full faces of the clamp
– Gently close the clamp by tipping the face with the inspection window toward the materials, resting it on top of them.
– Adjust the quantity and length of the materials by pulling them through the window, or by reopening the clamp
– Grip the base of the clap with one hand, lifting it off the table, and flip the last face underneath to form a closed unit
– With an appropriate plier, clamp the obtained material mix and pull it out to insert it in the dubbing loop
– Designed by Luca Barosselli
– 100% Made in Italy
– The orange color ensures optimal contrast even on natural-colored fibers
– Always store the BlendMaster Clamp closed with the printed side up
– If the hinges become stiff, lightly lubricate the hinge pivot points
– Keep away from heat sources
– Clamp sizes (fully extended): L16 x W8 cm
– Packaging sizes: L180 x W70 x H13 cm